Altair WBP-200 Instrukcja Naprawy Pobierz pdf (Strona 16)

7. BATTERY CHARGER ALTAIR WBPC-210

The battery charger ALTAIR WBPC-210 allows to

charge up to four beltpacks ALTAIR WBP-210/WBP-212

simultaneously. The charge time is approximately of

four hours with the batteries totally discharged.

7.1 CHANGING THE FUSE

The battery charger ALTAIR WBPC-200 is set to operate from 100 VAC, 50-60Hz to 240VAC,

50-60Hz.

Make sure that the unit is disconnected of the mains.

In the unit rear panel, is placed the mains connector, and the fuse holder. The box bellow this

mains connector is called fuse holder. Take out the fuse holder.

Upon extracting the fuse holder, the fuse will appear, take out it and

change for the new one.

Insert the fuse holder into the mains connector again.

Make sure that the fuse is the right one for the selected voltage:

FUSE

T2A/250VAC.

CAUTION: Always make sure upon changing the fuse, that this is the adequate for the selected

mains voltage (T2A/250VAC).

7.2 CONNECTING TO THE MAINS

The connection of the battery charger ALTAIR WBPC-210 power supply to the

mains takes place by the cord included in the box.

Make sure that the beltpack are disconnected from the battery charger.

Insert the female I.E.C. connector of the tripolar cable into the unit power supply

male connector, placed at the rear panel

Insert the male connector of the tripolar cable into the mains plug.

In that moment the charge LEDs indicators will light in green colour, indicating

that the unit is turned on.

CAUTION: Make sure that the mains voltage is the correct as well as their fuse is the adequate.

WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACK

1 2 ... 11 12 13 14 15 16 17 18 19 20

Brak uwag

Altair WBP-200 Instrukcja Naprawy Strona 16