7
BP-200 SINGLE CHANNEL WIRELESS BELTPACK.
If the base on which it is registered finds within its reach, the LED of IN RANGE
will begin to blink and the audio will be opened. At this moment you can begin to use
your beltpack ALTAIR WBP-200.
To turn off the beltpack, press and hold two seconds the ON/OFF switch when the
beltpack is turned on. In this moment will sound the buzzer (if the buzzer is turn on) and when
the ON/OFF switch it is depressed, the beltpack it is turned off.
If the ON/OFF switch it is short pressed, the beltpack will show us the battery status
(LOW BAT led – 10%, BUZZ ON/OFF led – 40%, MIC ON/OFF led – 70% and IN RANGE led
– 100%).
IN RANGE LED
The IN RANGE led when blinks indicates that the beltpack is in the
station base range, if it is turn on without blinking, indicates that the
beltpack is not in the station base range.
VIBRATOR ON/OFF
When we press at the same time the MIC ON/OFF switch
and the BUZZ ON/OFF switch we turn on/off the vibrator. If the
vibrator it is in on mode, the vibrator turn to off mode and if the vibrator
it is in off mode, the vibrator turn to on mode.
If the vibrator it is turned on, when a call is received, the unit vibrates.
The state of the VIBRATOR (on/off), it is stored in the unit.
STANDBY MODE
When the beltpack is turn on and we press the ON/OFF switch
and the VOLUME DOWN switch at the same time,
the beltpack change to STANDBY mode. In this mode,
the beltpack can receive CALLs, but the audio it is disconnected. This
mode is useful to save battery, since the beltpack less consumes 5
times than in full duplex state.
To exit from STANDBY mode, press the ON/OFF switch briefly.
MIC GAIN ADJUSTMENT
The mic gain adjustment allows attenuating or amplifying the mic signal. When
press the MIC ON/OFF switch and at the same time the UP or
DOWN VOLUME switch, the mic gain it is adjusted,
the four leds of the beltpack turn to indicate the mic gain.
There are 15 steps of mic gain, the LOW BATTERY led indicates the first
step, the BUZZ ON/OFF led indicates the sixth step, the MIC ON/OFF led
indicates the eleventh step and the IN RANGE led the fifteenth step of the
mic gain.
The MIC GAIN, it is stored in the unit. Press again to switch on if necessary.
SIDETONE GAIN ADJUSTMENT
The sidetone gain adjustment allows attenuating or amplifying the own mic signal
that we listen in our headphones. When press the BUZZER ON/OFF
switch and at the same time the UP or DOWN VOLUME
switch, the sidetone gain it is adjusted, the four leds of the
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji