Altair WBS-200 Dokumentacja Strona 7

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 22
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 6
7
WB-200 SERIES INTERCOM SYSTEM — WBS-200 DUAL CHANNEL WIRELESS BASE STATION
Make sure that the fuse is the right one: 2A slow blow type - T2A
CAUTION: Always make sure after changing the fuse, that it is the right one.
CONNECTING TO THE MAINS
The connection of the intercom master station power supply to the mains takes
place by a standard cord included in the box.
Make sure that the unit power switch is at 0 position (turned off).
Insert the female I.E.C. connector of the tripolar cable into the unit power supply
male connector, placed at the rear panel.
Insert the male connector of the tripolar cable into the mains plug.
Turn on the unit power switch. In that moment the CALL
LED indicator will light slightly, indicating that the unit is turned
on.
CAUTION: Make sure that the mains voltage is the correct as well as their fuse is the right one.
ANTENNA MOUNTING
The base station has two antenna connectors (ANT 1 and ANT 2), to mount two antennas
(provided). For optimal performance it is recommended that the two antennas form a 90º angle.
If the base station goes in rack of 19” is important to place the unit in the upper area, to avoid
interferences with the other rack units and the antennas radiate in open space. The best
performance is obtained with the unit to the air without placing it in rack.
In order to increase the operating range of the system you can either install one of the
provided antennas in an upper position or use a high gain directional antenna. See the
accessories section for more information.
PROGRAM INPUT CONNECTION
The intercom base station program input signal is carried out through a XLR-3-31 female
connector. The input connection is balanced, with a nominal impedance of 40 K (20 K
unbalanced). The next list shows the input pins correspondence as A.E.S recommends:
PROGRAM INPUT - XLR-3-31
PIN 1
0 V
PIN 2 HOT (+)
PIN 3
COLD (-)
Przeglądanie stron 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag